Advertisement
Force
Use common sense during disassembly and assembly,
excessive force can cause expensive or hard to repair damage.
When necessary, remove screws that have a non-permanent
locking agent applied using an impact driver. Use a
plastic-faced mallet whenever tapping is necessary.
Gasket, O-ring
Hardening, shrinkage, or damage of both gaskets and O-rings
after disassembly can reduce sealing performance. Remove old
gaskets and clean the sealing surfaces thoroughly so that no
gasket material or other material remains. Install the new
gaskets and replace the used O-rings when re-assembling.
16
Advertisement
