Gigabyte GA-F2A85XN-WIFI User Manual page 55

C-1. UEFI RAID Configuration
This mode supports Windows 8 64-bit installation only.
Step 1:
In BIOS Setup, go to BIOS Features and set OS Type to Windows 8 and CSM Support to Never. (Figure 2)
Save the changes and exit BIOS Setup.
Step 2:
Restart your computer and press <F12> to enter the boot device configuration menu. Use the up or down arrow
key to select UEFI: Built-in EFI Shell. Press <Enter> to access the screen as shown in Figure 3. Follow the
steps below and enter the commands to access the RAID setup utility.
1. Enter drvcfg at Shell and press <Enter>:
Shell> drvcfg
2. When Drv [XX] Ctrl [XX] Lang [eng] appears, enter the following commands at Shell again:
Shell> drvcfg -s XX XX
(XXs are the values shown in the brackets after Drv and Ctrl above, which may vary by hard drives.)
Then press <Enter> to enter the RAID setup utility.
EFI Shell version 2.31 [4.653]
Current running mode 1.1.2
Device mapping table
fs0 : Removable HardDisk
PciRoot (0x0)/Pci (0x10, 0x0)/USB (0x3, 0x0)/HD (1.MBR,0x016777a6, 0x3f, 0x1e1fc0)
fs1 : Removable CDRom
PciRoot (0x0)/Pci (0x11, 0x0)/Scsi (0x2, 0x0)/CDROM (0x1,0x6e, 0X1A0263)
......
Press ESC in 1 seconds to skip startup.nsh, any other key to continue.
Shell> drvcfg
Configurable Components
Drv [59] Ctrl [CF] Lang [eng]
Shell> drvcfg -s 59 cf
Figure 2
Alias hd12d0b blk0
Alias cd14c0b blk1
Figure 3
- 55 - Drivers Installation