Accessories; Wiring Diagram - RIDGID TP1300 Operator's Manual

Maintenance (continued)
WARNING: To reduce the risk of
thrown blades and other cutter
head parts make sure the knife lock
bar containing the seven knife lock
screws is positioned as shown in
the cutter head side view picture.
9. Push the installed knife in firmly.
Visually check that the knife edge
is parallel to the cutter head slot.
10. Tighten the seven (7) knife locking
screws.
NOTE: Move wrench right to left to
tighten.
11. To rotate the cutter head to the next
knife, release the cutter head lock.
Hold down on the red lock lever
located on the left side and rotate the
cutter head.
12. Release the red lock lever and con-
tinue to rotate the cutter head until it
locks. This should correctly position
the second knife.

Accessories

Do not use any accessory unless you
have received and read complete instruc-
tions for its use.

Wiring Diagram

Power Cord
Switch
Black
White
Green
Grounding Wire
13. Repeat procedures 5 through 10 for
the second knife.
14. Check that all knife lock screws are
tight and reinstall the dust chute.
Knife Lock Screws
Power Tool Universal Legset....... AC9910
Dust Collector.............................. AC8640
Replacement Knives ................... AC8630
Over Load
Motor Lead
26
Knife Lock Bar
Motor Lead
Motor