Assembling Upper Stiffeners - RIDGID TP1300 Operator's Manual

Assembling Legset (continued)
Assembling Lower Stiffeners (cont.)
2. Assemble the lower stiffeners to the
legs as shown. Finger tighten the nuts.
Make sure:
a. The long and short lower stiffeners fit
inside the legs.
b. The short stiffeners must be assem-
bled on opposite sides of the leg set.
(The same for the long stiffeners.).

Assembling Upper Stiffeners

1. Locate the following parts and hard-
ware:
16 Carriage Bolts M8 x 1.25
16 Hex Flanged Nuts M8 x 1.25
2 Long Upper Stiffeners
2 Short Upper Stiffeners
2. Assemble the upper stiffeners to the
legs as shown. Finger tighten nuts.
Make sure:
a. The long upper stiffeners go over the
short upper stiffeners. Make sure the
stiffeners go inside the legs.
b. The short upper stiffeners go oppo-
site each other, same as the long
upper stiffeners.
c. The planer mounting holes in the top
of the legset are aligned.
3. Go back and tighten all nuts.
Nut
Short
Lower
Stiffener
Carriage Bolts
M8 x 1.25
Long Upper
Stiffener
Nut
Short Upper
Stiffener
Long
Lower
Stiffener
14
Carriage
Bolt
Hex Flanged Nut
M8 x 1.25
Short Upper
Stiffener
Long
Upper
Stiffener
Carriage
Bolt
Short
Lower
Stiffener