Panasonic ES-8101 Operating Instructions Manual page 6

Cleaning
6
1. Disconnect the power cord
from the shaver.
. Apply some hand soap and
some water to the outer foil.
3. Press the OFF/ON switch for
more than  seconds to
activate the turbo mode for
"sonic" vibration cleaning.
or flash around
•
randomly.
After about 0 seconds, it
•
will be automatically turned
off, or you can turn it off by
pressing the OFF/ON switch.
4. Remove the system outer foil
and press the OFF/ON switch
for more than  seconds to
activate the turbo mode for
"sonic" vibration cleaning and
clean it with running water.
5. Wipe off any drops of water
with a dry cloth.
6. Remove the system outer foil
and the foil frame to allow
them to dry completely.
Caution for turbo mode
Shaving in turbo mode may damage your skin. Turn the shaver
•
off and then on again to cancel turbo mode.
Do not place your fingers on the OFF/ON switch while using
•
the shaver. This may cause the shaver to turn off or enter turbo
mode. Place your fingers on the finger rest while using the
shaver.
Replacing the system outer foil and the inner
blades
system outer foil
inner blade
Replacing the system outer foil

2 3
once every year
once every two years
1. Press the foil frame release
buttons and lift the system
outer foil upwards as
illustrated.
. Press the system outer foil
release buttons and pull down
the system outer foil as
illustrated.
3. Insert the system outer foil
until it clicks.
Always attach the system
•
outer foil in proper direction.
Always insert the system
•
outer foil to the foil frame
when attaching to the shaver.