Haier HWD100-BP14939 User Manual page 18

Table of Contents

Advertisement

6-Daily use
EN
6.10 Start wash programme
Press "Start/Pause" button (Fig. 6-8) to start. The LED stops flashing
and lights up continuously.
Appliance operates according to present settings.
Changes are only possible by cancelling the programme.
6.11 Interrupt / cancel wash programme
To interrupt a running programme press gently "Start/Pause". The LED above the button
is flashing. Press it again to resume operation.
To cancel a running programme and all its individual settings:
1. Press "Start/Pause" button to interrupt the running programme.
2.
Turn the knob to select the programme "Spin" and press "Speed" (selcet speed "0")
to drain the water.
3. After select a new programme and
6.12 After washing
Note: Door lock
For safety reasons the door is locked partially during the washing cycle. It is only pos-
sible to open the door at the end of the programme or after the programme was can-
celled correctly (see description above).
In case of high water level, high water temperature and during spinning it is not pos-
sible to open the door;
1. At programme cycle end
2.
3. Remove laundry as soon as possible to go easy on it and to prevent more wrinkling.
4.
5. Unplug the power cord.
6. Open the door to prevent formation of moisture and odours. Let it open while not used.
Note: Standby-mode / energy -saving mode
The switched on appliance will go into standby-mode if it will not be activated within 2
minutes before starting the programme or at the end of programme. The display
switches off. This save energy.
6.13 Activate or deactivate the buzzer
The acoustic signal can be deselected if necessary:
1. Switch on the appliance.
. 3
Press the "Dry level" button and "Temp." button and "Extra Rinse" button at the same
time for about 3 seconds. " BEEP OFF" will be displayed and the buzzer will be deactivated.
For activating the buzzer p ress these three buttons at the same time again. "bEEP ON "
will be displayed.
18
start it.
is displayed.
is displayed.
2. Select ''Self clean'' programme
l
6-8

Advertisement

Table of Contents
loading

This manual is also suitable for:

Hwd90-b14939s8

Table of Contents