Table of Contents
Advertisement
46
www.aeg.com
Problem
The spin phase does
not operate or the
washing cycle lasts
longer than usual.
There is water on the
floor.
You cannot open the
appliance door.
The display does not
show the wireless indi‐
cator
.
The App cannot con‐
nect to the appliance.
Possible solution
•
Set the spin programme. If the drain programme is not availa‐
ble in the programme dial, it can be set via App'.
•
Make sure that the drain filter is not clogged. Clean the filter, if
necessary. Refer to "Care and cleaning".
•
Adjust manually the items in the tub and start the spin phase
again. This problem may be caused by balance problems.
•
Make sure that the couplings of the water hoses are tight and
there is not water leakages.
•
Make sure that the water inlet hose and the drain hose have
no damages.
•
Make sure you use the correct detergent and the correct
quantity of it.
•
Make sure that a washing programme that ends with water in
tub, has not been selected.
•
Make sure that the washing programme is finished.
•
Set the drain or the spin programme if there is water in the
drum. If the spin and drain programmes are not available in
the programme dial, they can be set via App.
•
Make sure that the appliance receives electrical power.
•
This problem may be caused by a failure of the appliance.
Contact the Authorised Service Centre.
If you need to open the door, please read carefully "Emergen‐
cy door opening".
•
Make sure that the Remote Start Mode is not activated. Deac‐
tivate it.
•
Check the wireless signal.
•
Make sure that the wireless connection is on. Refer to para‐
graph "Configuring the washing machine wireless connection"
in "Wi-Fi - Connectivity setup" chapter.
•
Check your home network and router.
•
Restart the router.
•
Contact your wireless service provider if there are further
problems with the wireless network.
•
Check the wireless signal.
•
Check if your smart device is connected to the wireless net‐
work.
•
Check your home network and router.
•
Restart the router.
•
Contact your wireless service provider if there are problems
with the wireless network.
•
The appliance, the smart device, or both, need to be config‐
ured again because a new router has been installed or the
router configuration has been changed.
Advertisement
Table of Contents
