Panasonic AJ-LT95 Operating Instructions Manual page 48

Setup menus
AUDIO menu
Item
Superimposed
No.
display
714 EMPHASIS
726 REC CUE
727 PB FADE
728 EMBEDDED AUD
731 CUE OUT SEL
732 CUE SLOW
The underlining indicates the factory setting.
Setting
Superimposed
No.
display
0000 OFF This selects emphasis for the audio signals.
0001 ON
This selects the input signals to be recorded on the cue track.
0000 CH1 0: Audio CH1 input signals
0001 CH2 1: Audio CH2 input signals
0002 CH1+2 2: Audio CH1 and CH2 mixed signals
0003 CH3 3: Audio CH3 input signals
0004 CH4 4: Audio CH4 input signals
0005 CH3+4 5: Audio CH3 and CH4 mixed signals
This selects the audio edit point (IN and OUT) processing during
playback.
0000 AUTO 0: The processing complies with the status set for recording.
0001 CUT 1: Cut processing is forcibly initiated.
0002 FADE 2: Fade processing is forcibly initiated.
This selects whether to embed the audio data in the serial output.
0000 OFF 0: The audio data is not embedded.
0001 ON 1: The audio data is embedded.
This selects whether the cue audio signal is to be output to the
main system output in the search mode.
0000 OFF 0: The cue audio signal is not output.
0001 ON 1: The cue audio signal is output.
This selects the tape travel mode (cue track playback mode)
during slow playback.
0000 STEP 0: The output pictures are given priority, and step feed is
performed.
0001 LINEAR 1: Cue track playback is given priority, and the tape travels in the
linear mode.
<Notes>
When "1: LINEAR" has been set:
O Set the TC/CTL switch to TC. The CTL counter may not
operate properly.
O The picture may not appear as clearly as in the step mode.
48
Description of setting
V V
T T
R R
1 2
[ [
[ [
[ [
[
[ [
[ [