Hardware Specifications; Electrical Safety Precautions - Delta PCI-DMC-F01 User Manual

PCI-DMC-F01 User Guide

1.2 Hardware Specifications

Motion Control

Supported Module: Delta ASDA -A2-F Servo Drive

Homing modes: 35 types (controlled by DMCNET parameter settings)

Acceleration mode: T-curve, S-curve

Interpolation modes: linear, arc, helical, and continuous
DMCNET

Ring quantity: 1 set

Serial Control Interface: half duplex RS-485 with transformer isolation

Cabling Type:CAT-5e STP Ethernet cable (24AWG/4Pairs)

Communications distance: Maximum 30 meters (6 slave module+6 I/O
module)
General

Axis card size (including bracket): 127mm x 56mm x 20mm (l x w x h)

PCI specifications: ver. 2.2; Supports 32-bit, 3.3V/5VDC operating mode

Power Consumption: +5V DC at 0.5A typical

Surge Voltage Tolerance: 1500VAC(Primary-secondary);

ESD:8KV Air Discharge

EFT: Power Line-2KV

RS: 80MHz ~ 1GHz, 10V/m

Operating temperature: 0

1.3 Electrical Safety Precautions

1. To prevent electrical hazards, please disconnect the system from the power
supply before moving the system.
2. Make sure that all power supply cables have been disconnected before
connecting or disconnecting any signal wires from the main board.
3. Please make sure that the voltage of the power supply has been set to the
standard voltage used for your current country/region. If you are not sure what
the voltage of your local power supply is, please contact your local electrical
company.
4. If the power supply is damaged, do not attempt to repair it by yourself. Please
contact professional technicians or your distributors for assistance.
1-2
1500VAC(Primary-PE)
o o
C ~ 50 C
Chapter 1 Installation Environment
July 2014