Advertisement
EA-1 EasyStart
!
Each time you record a new knob or switch change with the Motion sequence function, it will OVERWRITE the previous
Motion sequence for that part. If you're not satisfied with the Motion Sequence you just recorded, simply re-record it, or
Clear the Motion Sequence. One Motion sequence, using one knob rotation, can be recorded for each Part. Two knob
rotations can be recorded for the Delay Motion Sequence (See the Owner's Manual, pages 18, and 28 for more
information)
More Pattern editing:
Copy the previous pattern and change the pattern length:
Select pattern d.64
1.
d.63. Don't PLAY pattern yet...
holding Shift press an unlit key between 1 and 4 to change the pattern length to this new value..
View the step data in the pattern:
While pattern plays, press each part key, and note that the step keys light to indicate where each part is set to trigger
2.
along the 16-step grid
- and loops from bars 1-2.
Continue playback of pattern
3.
in Select section moves to 2
Trigger Settings for the two different measures of Part 4 press the HI-HAT Close key, so that it lights.
Edit the trigger settings for Part 2:
Press Select < or > keys until bar 1's red LED is lit - to view the trigger settings for Part 2, bar 1. Let the pattern continue
4.
to play
press all the lit keys, to turn them off
rest of the data for Part 2 stays the same - for bar 2 press Select > key to move to bar 2 press any desired step
keys to change trigger settings for the Part 2, bar 2
Work with the Swing function:
Select pattern A.27 PLAY pattern to hear how it sounds press STOP
5.
key 8 (Swing) - a value of 50 will flash in the display
(flashing), to set new Swing value
press step key 8.
Rotate DIAL to set value to "50" press step key 8 again to re-set Swing value
6.
"straight" 16-beat pattern
press WRITE rotate DIAL to select pattern d.63
hold down Shift to see the pattern's length. (One of keys 1-4 lights accordingly
watch Select LED section (above step keys). Note that green LED indicates movement through
select Part 2 with the Part Select key (it will light) press Select > key 1x - the red LED
bar in pattern press Select < key 1X to move back to 1
nd
Listen as pattern loops - when bar 1 plays again, no steps will play - the
PLAY pattern to hear new swing setting
press STOP.
press WRITE again, to copy pattern d.64 to
press the STOP key.
hold down the Shift key and press step
rotate the DIAL to a setting of "65" press step key 8 again
STOP pattern
4
bar. Note that you're viewing
st
hold down Shift and
PLAY pattern again - to hear
while
Advertisement
