Advertisement
Realtime Pattern Control
!
Before you continue, turn OFF memory protect: Press GLOBAL
"off"
Copy a preset pattern to a new location:
Press PATTERN
1.
DIAL to pattern d.64
In-store demo suggestion:
Tweak the copied pattern:
Change Tempo: (see "Changing Tempo" on the previous page).
1.
Retrigger pattern Playback: As pattern plays, hold down Shift and press PLAY repeatedly, to "force" pattern playback
2.
to first beat of the measure.
Tweak the pattern: Choose Part 1 or Part 2
3.
set of part sounds using the existing pattern
repeatedly and select Tempo Delay with the Type key
Each part has two oscillators. Change the waveforms with OSC1 and OSC2 keys
4.
with OSC Balance knob
Tweak the pattern data itself: Press the Keyboard key so it is off (unlit) As pattern plays, select either Part press to
5.
add/remove steps from the 16 step keys (lit/unlit).
Motion Sequencing:
Record Motion sequences in the previous pattern:
Select Part 1 with the Part Select key (it will light)
1.
previous Motion sequence for Part 1
Press to select Part 1 key (it will light)
2.
light)
press REC key (left of STOP). REC will light, and PLAY will flash.
Press PLAY to begin recording
3.
will continue to play - you'll hear new Motion sequence while pattern loops, press Motion Seq key to select Smooth or
Trig Hold, and listen to difference in playback.
Press STOP press to select Part 2 key (it will light), then select either Smooth or TrigHold as type of Motion
4.
Sequence press REC
2 press STOP
Press the PATTERN key to return to PATTERN mode.
press CURSOR
press WRITE again to copy the source pattern to d.64.
Use pattern d.64 as the edit "target pattern" for all of your demos!
tune OSC2 up from the first with OSC2 Pitch Ofs.
rotate Cutoff knob. When pattern reaches last step, REC light will go out and pattern
press PLAY to record toggle Reverse key off / on, to record new Motion sequence for part
press WRITE 2x to write pattern with the two new Motion sequences.
to set to "Pattern"
rotate DIAL to select any pattern
work with the knobs and switches as pattern plays - create an edited
with the Keyboard key lit, try striking any of the 16 trigger keys
tweak effect with the Depth and Time knobs.
Record knob and switch changes for each part and the delay
hold Shift and press step key 11 (Clear Motion) 2x, to clear
repeat this step for Part 2.
in PART edit section, press Motion Seq to select Smooth or Trig Hold (it will
3
CURSOR to Protect
Rotate DIAL to
press WRITE
change the Balance between them
EA-1 EasyStart
rotate
Advertisement
