Philips Sonicare ExtertClean 7000 Manual page 13

Available languages

2 Place the toothbrush bristles against the teeth at a

slight angle (45 degrees). Pressing firmly to make the

bristles reach the gumline or slightly beneath the

Note: Keep the center of the brush in contact with the

teeth at all times.

3 Press the power on/off button to switch on the Philips

4 Gently keep the bristles placed on the teeth and in the

gumline. Brush your teeth with small back and forth

motion so the bristles reach between the teeth.

Continue this motion throughout your brushing cycle.

Note: The bristles should slightly flare. It is not

recommended to scrub as you would with a manual

Note: If you apply too much pressure, you will be

alerted by a change in vibration of the handle and the

brush head replacement reminder flashing amber.

5 To clean the inside surfaces of the front teeth, tilt the

brush handle semi-upright and make several vertical

overlapping brushing strokes on each tooth.

6 After you have completed the brushing cycle, you can

spend additional time brushing the chewing surfaces

of your teeth and areas where staining occurs. You

can also brush your tongue, with the toothbrush

switched on or off, as you prefer.

Note: Your Philips Sonicare toothbrush is safe to use on

braces (brush heads wear out sooner when used on

braces) and dental restorations (fillings, crowns, veneers)

if they are properly adhered and not compromised.