2 2 . . 3 3
C C o o n n n n e e c c t t i i n n g g t t h h e e I I n n t t e e r r n n a a l l B B a a t t t t e e r r y y
NOTE 1
NOTE 2
Figure 6. Internal Battery Connection
1.
Remove the center cover of the front panel.
2.
Push left cover toward to right direction.
3.
Open the left side of the front panel.
NOTE
A small amount of arcing may occur when connecting the internal batteries. This is normal and will not harm
personnel. Connect the cables quickly and firmly.
4.
Connect the two battery connectors together.
5.
Put back the front panel, then clip the center cover.
2 2 . . 3 3 . . 1 1 U U P P S S T T o o w w e e r r I I n n s s t t a a l l l l a a t t i i o o n n
Tip If you ordered other UPS accessories, refer to specific user manuals to check the tower installation with
the UPS.
To install the cabinet:
1.
Place the UPS on a flat, stable surface in its final location.
2.
Always keep 6" or 150 mm of free space behind the UPS rear panel for ventilation.
Place the UPS on a flat, stable surface in its final location.
Always keep 150 mm of free space behind the UPS rear panel.
1
2
4
A ribbon cable connects the LCD control panel to the UPS. Do not pull on the cable or
disconnect it.
Tripp Lite by Eaton SmartOnline Series User Guide 614-21325—Rev 01
Connecting the Internal Battery
3
5
9