Table of Contents
Advertisement
Installation
ACCESSORIES
Check the accessories before installations.
Operating
Instruction book
Remote Control battery installation
Requires two AA batteries.
1. Push the section marked with
an arrow while lifting the cover
up to open it.
Precaution on battery use
Incorrect installation can cause battery leakage and corrosion that will damage the remote control transmitter.
Observe the following precautions:
1. Batteries should always be replaced as a pair. Always use new batteries when replacing the old set.
2. Do not combine a used battery with a new one.
3. Do not mix battery types (example: "Zinc Carbon" with "Alkaline" ).
4. Do not attempt to charge, short-circuit, disassemble, heat or burn used batteries.
5. Battery replacement is necessary when remote control acts sporadically or stops operating this unit.
Helpful Hint:
Whenever you remove the batteries, you may need to reset the remote control infrared codes. We recommend
that you record the code on page17-24, prior to setting up the remote.
AC Power Cord
2. Install the batteries as shown in
the battery compartment.
(Polarity + or - must match the
markings in the compartment).
Two AA size
Remote Control
Unit
3. Close the cover by inserting the
top end first.
Battery for the Remote
Control Unit
(2×AA (IEC R6) size)
7
Advertisement
Table of Contents
