Chevrolet Silverado 2500 HD 2024 Owner's Manual page 166

164 Infotainment System
Direct commands are more clearly
understood by the system. An example of a
direct command is Dial <number>.
If a cell phone number was saved with a
name and a place, the direct command
should include both. For example Call
<name> at work.
Voice Recognition for the Radio
When voice is started, the voice recognition
commands for AM, FM, SiriusXM (if
equipped), and media apps (if supported) are
available.
Play <AM frequency> AM : Tune to the
radio station frequency identified in the
command (like nine fifty ).
Play <FM frequency> FM : Tune to the
radio station frequency identified in the
command (like one oh one point one ).
Play channel <SXM channel number> on
SiriusXM : Tune to the SiriusXM radio
station channel number identified in the
command. This command may require an
online connection.
Play <SXM channel name> on Sirius XM :
Tune to the SiriusXM radio station channel
name identified in the command. This
command may require an online connection.
Play <Media> on <Audio Source> : Play
media like a song or channel using a
specified audio source such as Pandora or
Spotify. This command may require an
online connection.
Voice Recognition for the Phone
Make sure the phone is paired using
Bluetooth to use the phone related voice
commands.
Call <contact name> : Initiate a call to a
stored contact. The command may include
location if the contact has location numbers
stored. You must accept Personal Results
permission during set up for access to the
contacts.
Call < phone number> : Initiate a call to a
phone number of seven digits or 10 digits.
Send a message to <contact name> : Send
a message to a stored contact.
Voice Recognition for Navigation
Navigation commands can be used to start,
cancel route, or add way points/POI.
Navigate to <destination address> :
Initiate navigation to the address in the
command.
Find a <Place of Interest> : Find and
initiate navigation to a POI in the command.
Add <destination> on my way : Adds a
way-point to the current route.
Take me home : Starts navigation to
Home location set in Google maps.
Onboard Vehicle Commands
These commands can be used to adjust
vehicle temperature, control window
defrosters and obtain fuel information.
Turn on the A/C : Turns on the air
conditioning.
How much gas do I have left : Find out
how much fuel your vehicle has left.
Set temperature to <desired number>
degrees : Set to a specific temperature
inside your vehicle.
Phone Assistant Voice Recognition
While a device is connected via Bluetooth,
Android Auto, or CarPlay, press and hold
on the steering wheel controls to pass
through and launch the Voice Assistant on
the connected mobile phone (e.g, Google
assistant, Siri, etc.).