Obtaining And Installing Ipsu; Using Ipsu To Find The Bridge's Ip Address - Cisco Aironet 1300 Series Installation Manual

Using the IP Setup Utility

Obtaining and Installing IPSU

IPSU is available on the Cisco web site. Follow these steps to obtain and install IPSU:
Step 1 Use your web browser to go to the Cisco Software Center at the following URL:
http://www.cisco.com/public/sw-center/sw-wireless.shtml
Step 2 Select Option #1: Aironet Wireless Software Selector.
For the Product Type, select Wireless Bridge and click Submit.
Step 3
Select 1400 Series for the model number and click Submit.
Step 4
Select Current Release (Recommended) and click Submit.
Step 5
Under Utilities, select IPSUvxxxxxx.exe.
Step 6
On the Encryption Authorization Form, enter the requested information, read the encryption
Step 7
information, and check the boxes that apply. Click Submit.
Read and accept the terms and conditions of the Software License Agreement.
Step 8
Select the IPSU file again to download it.
Step 9
Step 10 Save the file to a temporary directory on your hard drive and then exit the Internet browser.
Double-click IPSUvxxxxxx.exe in the temporary directory to expand the file.
Step 11
Double-click Setup.exe and follow the steps provided by the installation wizard to install IPSU.
Step 12
The IPSU icon appears on your computer desktop.

Using IPSU to Find the Bridge's IP Address

If your bridge receives an IP address from a DHCP server, you can use IPSU to find its IP address.
Because IPSU sends a reverse-ARP request based on the bridge MAC address, you must run IPSU from
a computer on the same subnet as the bridge. Follow these steps to find the bridge's IP address:
Step 1 Double-click the IPSU icon on your computer desktop to start the utility. The IPSU screen appears (see
Figure
Cisco Aironet 1300 Series Bridge Hardware Installation Guide
5-10
C I S C O C O N F I D E N T I A L - F i r s t D r a f t
5-3).
Chapter 5 Configuring the Bridge for the First Time
OL-5048-01