Panasonic BT-LH900 Operating Instructions Manual page 21

MAIN MENU
INPUT SELECT
Item Setting
FORMAT AUTO For selecting the signals whose input is to
1080/60I be accepted in the YPBPR mode and in the
1080/50I RGB mode.
1080/30P The signals can be set for each mode, and
1080/25P when the MODE item setting is switched
1080/24P from YPBPR to RGB or vice versa, the
1080/24PsF mode is automatically switched so that the
1035/60I signal format which has been set for the
720/60P mode now set is accepted.
576/50I AUTO:
480/60P
480/60I 1080/60I:
1080/50I:
1080/30P:
1080/25P:
1080/24P:
1080/24PsF:
1035/60I:
720/60P:
576/50I:
480/60P:
480/60I:
COMPONENT SMPTE For selecting the input level of the Y/Pb/Pr
LEVEL B75 signals.
SMPTE: This is selected when the signals
B75:
RGB-SYNC G-ON For switching the connector where the sync
EXT signal is to be accepted.
G-ON: This is selected when the sync
EXT: The sync signal is accepted at the
The underlined setting indicates the factory setting mode.
Description
All supported signals are accepted.
1080/60I or 1080/59.94I format signals
are accepted.
1080/50I format signals are accepted.
1080/30P or 1080/29.97P format signals
are accepted. (This setting takes effect
only when YPBPR is selected.)
1080/25P format signals are accepted.
(This setting takes effect only when
YPBPR is selected.)
1080/24P or 1080/23.98P format signals
are accepted. (This setting takes effect
only when YPBPR is selected.)
1080/24PsF or 1080/23.98PsF format
signals are accepted. (This setting takes
effect only when YPBPR is selected.)
1035/60I or 1035/59.94I format signals
are accepted. (This setting takes effect
only when YPBPR is selected.)
720/60P or 720/59.94P format signals
are accepted.
576/50I format signals are accepted.
480/60P format signals are accepted.
480/59.94I format signals are accepted.
are to be output from an MII VTR.
This is selected when the signals
are to be output from a Betacam
VTR.
signal has been superimposed onto
the G signal.
SYNC connector among the analog
component/RGBS connectors.
CONTROL
Item Setting
CONTROL LOCAL For selecting where the operations are to
REMOTE be initiated.
LOCAL: Only operations initiated from the
REMOTE: Remote control operations can be
<Notes>
≥ When REMOTE has been selected, the
≥ When REMOTE has been selected, only
LOCALENABLE DIS. For selecting whether to enable the input to
INPUT be switched to the main controls when
REMOTE has been selected.
DIS: When REMOTE has been selected,
INPUT:Even when REMOTE has been
BACKLIGHT TIME For displaying the total operation time of
the backlight.
Description
main controls can be performed.
Remote control operations cannot
be performed.
performed, but no operations
initiated by the main controls can
be performed although there are a
few exceptions to this.
" " lock mark appears on the status
display.
the settings of the CONTROL item and
LOCALENABLE item on the CONTROL
screen can be changed as menu
operations.
the input can no longer be switched
to the main controls.
selected, the input can be switched
to the main controls.
21