Copying Your Tapes (Dubbing) - Panasonic AG-VP320 Operating Instructions Manual

Copying Your Tapes (Dubbing)

Connection
VCR/ Camcorder (Hi-Fi)
OUT
VIDEO
L
AUDIO
R
1
Connect VIDEO OUT terminal on Playing VCR to VIDEO IN terminal on DECK.
To monitor the dubbing, also connect TV as shown.
2
Connect "L" and "R" AUDIO OUT terminals on Playing VCR to "L" and "R" AUDIO IN
terminals on DECK.
In place of Playing VCR, you can use other equipment, such as a Camcorder.
Simply connect the unit's Audio/Video outputs to DECK.
Playing (Source) VCR
1
Insert a pre-recorded tape.
2
3
Press PLAY, then PAUSE
immediately to enter PLAY/PAUSE
mode.
The operation of steps 4 and 5 must be done on the
4
Press PLAY to start dubbing.
Playing VCR starts playback.
5
Press STOP to stop dubbing.
■ ■ ■ ■ ■ To Monitor Dubbing on TV
1 Turn TV on and tune to the Recording
VCR channel (CH 3 or CH 4).
2 If Auto VCR/TV (see p. 34) is set to
"OFF," press VCR/TV on the remote for
VCR mode.
Note
• Dubbing tapes protected with Copy
Guard will result in poor quality
recordings.
Caution:
• Unauthorized exchanging and/or copying of copyrighted recordings may be copyright
infringement.
• Please note that some tapes cannot be dubbed on DECK.
Also, it is not possible to dub DVD/ Video CD/ CD to VHS tapes using DECK.
• When appears on the screen while a button is being operated, it means that the corresponding
operation is prohibited by DECK or the disc.
DVD/VCR DECK
IN FROM ANT.
OUT IN1
VIDEO
VHF/UHF
L
OUT TO TV
AUDIO1
R
playing and recording VCRs at the same time.
■ ■ ■ ■ ■ Selecting the Input Mode
TV
Front of DECK
VIDEO IN2 L-AUDIO
VHF/
(Audio/Video In Terminals
UHF
on the front of DECK are
available)
Recording (Editing) DECK
Insert a blank tape with record tab.
Press INPUT to set DECK Input mode
to LINE for Video Input.
(See "Selecting the Input Mode" below.)
Press REC, then STILL/PAUSE
immediately to enter REC/PAUSE
mode.
Press STILL/PAUSE to start dubbing.
DECK starts recording.
Press STOP to stop dubbing.
Method 1: Press INPUT repeatedly.
Channel Number ➛ ➛ ➛ ➛ ➛ LINE1 ➛ ➛ ➛ ➛ ➛ LINE2
Method 2: Press CH / .
Display will change as below.
1 2 3
Press
(CABLE)
LINE2 LINE1
• LINE1: For rear audio/video connection.
LINE2: For front audio/video connection.
IN2-R
Press
(TV)
or
125 69
35