Table of Contents
Advertisement
*Important: If a remote control button does not work when pressed,
Review, Replace or Clear Program Contents:
(Recording is not in progress)
1
Press PROG
to display Program List.
2
3
To Replace program...
or
To Clear program...
4
Press PROG
to end the programming.
Notes
• If you are using a Cable Box, the VCR's channel for Timer Recording must be set to the Cable Box
input channel and Cable Box must be manually set to the desired channel. Cable Box power must
be left on.
• 2 minutes before Timer Recording is performed, "PLEASE PREPARE FOR TIMER REC" appears
and TIMER Light-up Indicator flashes.
Be sure a cassette with record tab is loaded and DECK is in Stop mode.
• If a power interruption occurs while programming the timer, the timer program(s) may be canceled. If
"TIMER PROGRAMS WERE LOST DUE TO POWER INTERRUPTION" appears on-screen, please
re-enter the timer programs.
• If the start time for Timer Recording comes up during recording and playing back, Timer Recording will
not be performed.
Important notes when using DSS Receiver
• When recording programs via DSS Receiver, DSS Receiver must be left on.
• When recording programs via an antenna or cable, DSS Receiver must be turned off.
press the VCR button on the remote and try the button again.
Press
to select number.
Repeat Step 2 (p. 24) to
set new programs.
Press ADD/DLT.
To cancel a Timer
Recording in progress...
Hold down STOP in VCR mode for
a few seconds to cancel the Timer
Recording.
(The TIMER Light-up Indicator goes
out on DECK.)
• Any future daily or weekly recording will
be performed as programmed.
25
Hide quick links:
Advertisement
Table of Contents
