Advertisement
13. Proceed to install the PLOW HEADLIGHTS. Align one HEADLIGHT
BALL STUD MOUNT ADAPTER on the light tower tube with the
mounting hole and insert the threaded stud through each. Secure the
headlight with one 1/2" split lock washer and hex nut. Note: All snow-
plows are shipped with two BLACK DOME PLUGS that install at
either end of the light tower. For secure placement, apply a bead of
silicone around the perimeter of the plug prior to installation on the
light tower. Connect the terminals from the plow lights to the terminals
on the main lighting harness. Repeat the installation for the opposite
headlight.
14. Next, position the ROCKER SWITCH CONTROL STATION on the front
radius of the seat. Wrap the VELCRO® STRAP around the bench,
through the 2" metal D-ring and fasten. Finally, connect the white
power connector from the vehicle wire harness to the connector on
the control station. The power switch should be in the "MIDDLE" or
"OFF" position. Note: The operation of the draw latch can only be
controlled when the power switch is located in the "UP" position. See
the diagram to the right.
This completes the electrical assembly installation for the vehicle wire
harness and main lighting harness. You are now ready to perform all of
the test functions on the snowplow.
Dome
Plug
Apply a thin bead of silicone around the inside
perimeter of the polyethylene dome plugs prior to
capping the light tower ends. The silicone will
help retain the dome plug inside of the headlight
mount tube.
Elec. Assembly - Vehicle Harness (Cont.)
13
Advertisement
