Wireless Communication; Connecting Peripherals - Panasonic Toughbook CF-U1AQB1G2M Reference Manual

Troubleshooting (Advanced)
Wireless Communication (only for model with wireless LAN/Bluetooth/wireless
WAN)
Cannot connect to a network.
Access point is not detected.

Connecting Peripherals

An error occurs while installing the
driver.
Slide the wireless switch to turn on the wireless devices.
Set the device ([Wireless LAN] / [Bluetooth] / [Wireless WAN]) to [Enabled] in
the [Advanced - Wireless Configuration] menu of the Setup Utility (
Restart the computer.
Shorten the distance between the computer and the access point, and try the
detection again.
Confirm the following settings:
• [Wireless LAN] in the [Advanced - Wireless Configuration] menu of the Setup
Utility
Confirm that [Wireless LAN] is set to [Enabled]. (
• Wireless Switch
Slide the wireless switch to ON.
• Wireless Switch Utility
Confirm that Wireless LAN is ON.(
This computer uses channels 1 through 11
Check the channel being used by the access point.
*3
In the case of wireless communications, the frequency band being used can be divided
into segments, so that different communications can be conducted on each band
segment. A "Channel" refers to the individual frequency bandwidth divisions.
When you install a driver of card or peripheral device, make sure that the driver
is compatible with the operating system. If it is not compatible, malfunction may
occur. For information about the driver, contact the manufacturer of the
peripheral device.
85
page 68)
page 58)
*3
when using IEEE802.11b/g.
page 68).