Table of Contents
Advertisement
Note
mechanical stability and also electrically connects the front panel to
the chassis, which can improve the signal quality and
electromagnetic performance.
9. Cover all empty slots using either filler panels (standard or EMC) or slot
blockers with filler panels, depending on your application.
Note
panels, go to ni.com/r/pxiblocker.
10. Power on the chassis.
Verifying Hardware Installation for Host Targets
You can verify that the system recognizes the NI PXIe-7858R by using Measurement
& Automation Explorer (MAX).
1. Launch MAX by navigating to Start » All Programs » National
Instruments » MAX or by clicking the MAX desktop icon.
2. Expand Devices and Interfaces.
3. Verify that the device appears under Devices and Interfaces.
If the device does not appear, press <F5> to refresh the view in MAX. If the
device does not appear after refreshing the view, visit
troubleshooting information.
Verifying Hardware Installation for Remote Systems
You can verify that the system recognizes the NI PXIe-7858R by using Measurement
& Automation Explorer (MAX).
1. Launch MAX on the host computer.
2. Expand Remote Systems in the configuration tree and locate your system.
3. Install LabVIEW Real-Time Module2016 and NI R Series Multifunction RIO
Device Drivers August 2016 or later on your Remote System.
Tightening the top and bottom mounting screws increases
For more information about installing slot blockers and filler
PXIe-7858 Getting Started
ni.com/support
for
© National Instruments
7
Advertisement
Table of Contents
