Table of Contents
Advertisement
5. Connecting the cables
① Pass the pedal cable extended from E through the gap of D
to the rear side of the instrument and insert the cable to the
pedal connector on the bottom of A.
② Plug the AC adaptor into the power cord and insert it into
the [DC IN] jack.
③ Use the binders to secure the cables connected to B.
• Be careful with the orientation of the connector parts.
• Plug the connector straight in. Forcibly inserting it
could lead to a malfunction.
C
②
Insert the plug straight in at the correct angle. Avoid
applying excess force on it. Not doing so could bend
the pins or damage the plugs.
Keep the correct
Do not bend
angle
③
A
①
Do not pull
the cable
6. Attaching the headphone hook
Attach the headphone hook to the hole shown in the figure,
using the two tapping screws (4 x 14 mm) provided in the
same bag.
7. Rotating the adjustor
Make sure to rotate the adjustor on the rear side of E until the
adjustor touches the floor. Depending on the material and
condition of the floor, stepping on the pedal may generate
frictional noises between the pedal and the floor. If this hap-
pens, please use a felt or carpet pad between the floor and
the adjustor to fill the gap.
Using the instrument with the adjustor lifted off the
floor or forcibly pressed against the floor could cause
the pedal base to break.
When moving the instrument, make sure to lift it off
from the floor without dragging it.
Appendix
89
Advertisement
Table of Contents
