Fisher & Paykel DD24DV2T9 Troubleshooting

Troubleshooting
Possible Cause
Excessive water remaining above the filter plate,
after the rinse cycle. (This is displayed as an A3
fault. See user guide 'How to attend to a fault')
No water supply. (This is displayed as an A1 fault.
See user guide 'How to attend to a fault')
The dishwasher is beeping continuously
No program indicator lights up when the drawer
is opened
Water around water supply and drainage
connections
If product is tipping
If front panels are misaligned
Drawer doesn't close properly
• If a problem occurs, consult the 'Troubleshooting' section of the User guide.
• If after checking these points you still need assistance, please refer to the Service & Warranty book for warranty
details and your nearest Authorized Service Center, or contact us through our website, www.fisherpaykel.com
https://producthelp.fisherpaykel.com/us/Clean/DishDrawer%E2%84%A2/Double/DD24DV2T9_N/Installation_Guide_DD24DV...
What to Do
Check for a kinked drain hose, blocked or incorrectly drilled
out waste connection, highloop not properly installed, drain
hose not routed correctly or spray arms not in place.
Check water is connected and turned on.
There is a fault. See section 'How to attend to a fault' in the
User guide for further information and instructions.
Ensure power is connected and is switched on. If it is and
still no indicator ligths up, see the 'Preference options'
section of the 'Quick start guide'.
An option called 'Open drawer auto power-on' may need to
be turned on.
Check connections, existing plumbing and hoses for leaks.
Check rubber washer and hose clamp are correctly fitted.
Ensure the product is secured to the cabinetry.
Check and relevel product. Check the cabinetry is square.
For Integrated models, check and adjust front panel
alignment if necessary.
Ensure nothing is obstructing the drawer from closing
properly eg hoses or drawer latches.
Updated: Sun, 09 Apr 2023 04:12:19 GMT
Powered by
1