Removing The M.2 2280 Solid-State Drive From Slot 1 - Dell OptiPlex Micro Plus 7010 Owner's Manual

Steps
1. Align the notch on the M.2 2280 solid-state drive with the tab on the solid-state drive slot 0 (M.2 PCIe SSD 0).
2. Slide the M.2 2280 solid-state drive into the solid-state drive slot (M.2 PCIe SSD 0) on the system board.
3. Replace the screw (M2x3.5) that secures the M.2 2280 solid-state drive to the system board
Next steps
1. Install the side cover.
2. Follow the procedure in

Removing the M.2 2280 solid-state drive from slot 1

Prerequisites
1. Follow the procedure in
2. Remove the side cover.
About this task
NOTE: Depending on the configuration ordered, your computer may have an M.2 2230 or an M.2 2280 solid-state drive
installed in solid-state drive slot 1 (M.2 PCIe SSD 1) on the system board.
NOTE: This procedure is applicable for computers where an M.2 2280 solid-state drive is installed in solid-state drive slot 1
(M.2 PCIe SSD 1) on the system board.
The following image(s) indicate the location of the M.2 2280 solid-state drive in slot 1 and provides a visual representation of
the removal procedure.
After working inside your
Before working inside your
computer.
computer.
Removing and installing Customer Replaceable Units (CRUs) 41