Solid-State Drive; Removing The M.2 2230 Solid-State Drive From Slot 0 - Dell OptiPlex Micro Plus 7010 Owner's Manual

Steps
1. Insert the right-side front-bezel tabs into the corresponding slots on the side cover.
2. Push the left-side of the front bezel towards the side cover, snapping the tabs into position.
Next steps
1. Install the side cover.
2. Follow the procedure in

Solid-state drive

Removing the M.2 2230 solid-state drive from slot 0

Prerequisites
1. Follow the procedure in
2. Remove the side cover.
About this task
NOTE: Depending on the configuration ordered, your computer may have an M.2 2230 or an M.2 2280 solid-state drive
installed in solid-state drive slot 0 (M.2 PCIe SSD 0) on the system board.
NOTE: This procedure is applicable for computers where an M.2 2230 solid-state drive is installed in solid-state drive slot 0
(M.2 PCIe SSD 0) on the system board.
After working inside your
Before working inside your
computer.
computer.
Removing and installing Customer Replaceable Units (CRUs) 35