Table of Contents
Advertisement
If a clog prevents the normal flow of air to the motor, the thermal protector turns the
motor off automatically to allow the motor to cool in order to prevent possible
damage to the vacuum.
During this time the headlight remains on.
To correct problem, turn off and unplug vacuum, remove clogs, and/or clean/replace
filters.
Replace full bag if necessary.
Wait approximately thirty (30) minutes, plug vacuum in, turn on to see if thermal
protector has reset. Thermal protector will not reset if vacuum is not turned off even
if vacuum cools down.
Vac Gauge
The vac gauge detects when dust
bag needs changing or the vacuum is
clogged.
Check dust bag when vac gauge
indicates FULL.
If dust bag is full, change bag
according to CHANGING DUST BAG
section.
If dust bag is not full, check for clogs
according to REMOVING CLOGS
section.
Thermal Protector
- 16 -
Advertisement
Table of Contents
