Table of Contents
Advertisement
Next, the first batch parameter is displayed – batch 1, brew volume
Use the SCROLL UP and SCROLL DOWN buttons to adjust.
Press the STOP button to go to the next parameter – brew time.
Repeat the last step until all parameters are programmed for batch #1.
(See the chart below for an explanation of each parameter.)
Next, batch #2 programming begins.
Change to "ON" to enable.
(The top batch on each side cannot be disabled.)
After all batches are programmed, the temperature settings are next.
Important! After programming, you must press and hold the STOP button
until the display reads STO to save the settings and exit
programming mode, or changes will be lost.
You may exit programming at any time.
Example: 1.1 1.00
Example: 1.2 4.00
Display: 2.0 OFF
Display: 7
200
Advertisement
Table of Contents
