Table of Contents
Advertisement
Wireless LAN (MCS-838/MCS-636/MCS-434 only)
Problem
Check
Network cannot be
This unit and wireless LAN
accessed via wireless
router etc. are too far apart, or
LAN.
there is an obstacle between
them.
There is a microwave oven
or other device generating
electromagnetic waves near
the wireless LAN environment.
Multiple wireless devices are
connected to the wireless LAN
router.
Connection settings between
the unit and the wireless LAN
router etc. are not set up
correctly.
The IP address settings for
the unit and the wireless LAN
router etc. (including DHCP
settings) do not match.
The access point is set to
conceal the SSID.
The access point s security
settings use WEP 152-bit
length code key or shared key
authentication.
Unable to connect normally
using the Wi-Fi Direct function.
iPod/iPhone/iPad (MCS-838/MCS-636/MCS-434 only)
Problem
Check
Can t operate the iPod/
Is the iPod/iPhone/iPad
iPhone/iPad.
connected correctly
Does the unit support the iPod/
iPhone/iPad
Is the iPod/iPhone/iPad
experiencing a hangup
Remedy
Improve the wireless LAN environment by taking steps such as moving
the unit and wireless LAN router etc. closer together.
Use the unit in a place away from microwave ovens or others device
generating electromagnetic waves.
Avoid using devices generating electromagnetic waves as much as
possible when using the unit with a wireless LAN.
When connecting multiple wireless devices, their IP addresses must be
changed.
If the connection settings between the unit and the wireless LAN router
etc. are not set up correctly, connection settings much be performed in
order to connect the unit and the wireless LAN router etc.
Check the IP address settings of the unit and the wireless LAN router
etc. (including the DHCP setting).
If the unit s DHCP setting is on, turn the unit s power off, then turn
the power back on. Check that the IP address of the unit matches the
settings of the wireless LAN router etc.
If the unit s DHCP setting is off, set an IP address matching the network
of the wireless LAN router etc.
For example, if the wireless LAN router s IP address is "192.168.1.1",
set the unit s IP address to "192.168.1.
"255.255.255.0", and the gateway and DNS to "192.168.1.1".
( 1) Set the "
" in "192.168.1.
that is not assigned to other devices.
In this case, the SSID may not be displayed on the access point list
screen. If not, set the SSID etc. by setting the wireless LAN settings on
the receiver manually.
The unit does not support WEP 152-bit length code key or shared key
authentication.
Press RETURN on the remote control to close the Wi-Fi Direct Mode
Screen. Then press the
button and perform the controls again from
the Wi-Fi Direct Mode Screen.
Remedy
Make sure the iPod/iPhone/iPad is connected correctly. Also, try
disconnecting the iPod/iPhone/iPad then reconnecting it.
Confirm that the connected iPod/iPhone/iPad is supported by this unit.
Try resetting the iPod/iPhone/iPad and then reconnect it to the unit.
Troubleshooting
" ( 1), the subnet mask to
" to a number between 2 and 248
81
En
9
Advertisement
Table of Contents
