Tuner Setting - JVC HR-V610AG Manual

– Information on Multi-System Compatibility –
Tape-To-Tape Editing
There are 4 different types of recorded tape, depending on the signal recorded.
Recorded tape

Tuner Setting

IMPORTANT
Perform the following steps only if auto channel set has not been
set correctly by Auto Set Up function or if you have moved to a
different area or if a new station starts broadcasting in your area.
Your recorder needs to memorise all necessary stations in channel
positions in order to record TV programmes. Auto Channel Set
automatically assigns all receivable stations in your area so that
you can call them up with the PR+/– buttons without going
through any vacant channels.
Auto Channel Set
A
Access Main Menu screen, then Tuner
Set screen
Press MENU on the remote control. Press
rt
to place the pointer next to "TUNER
e
SET", then press OK or .
B
Perform Auto Channel Set
rt
Press to place the pointer next to
"AUTO CH SET", then press OK or
C
Select TV system
rt
Press to place the pointer next to the
appropriate TV system, then press OK or
e .
● Auto Channel Set will start.
AUTO CH SET
PLEASE WAIT
START FINISH
■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■
– – – – – – –
Press MENU to return to normal screen.
Playback equipment
MAIN MENU
FUNCTION SET
TUNER SET
INITIAL SET
[ / ]
[MENU] : EXIT
TUNER SET
CH EDIT
e
.
AUTO CH SET
[ / ]
[MENU] : EXIT
TV SYSTEM SELECT
B/G
D/K
I
M
[ / ]
[MENU] : EXIT
* M: For HR-V610AJ only
CH FRQ SYS CH FRQ SYS
01 150 BG 07 229 BG
02 165 BG 08 237 BG
03 195 BG 09 355 BG
04 205 BG 10 365 BG
05 213 BG 11 374 BG
06 221 BG 12 384 BG
[ / ] [ ] : DELETE
[ / ] : EDIT
[MENU] : EXIT
Recording circuit
IMPORTANT
● If no sound accompanies the picture or the audio sounds
unnatural on some channels that have been stored by Auto
Channel Set, the TV system setting for those channels may be
incorrect. Select the appropriate TV system for those channels.
Refer to "TV System Selection — When you see the picture but
the audio can't be heard or sounds unnatural" (
● Since your recorder memorises all detected stations even if the
reception condition is poor, some of those stored stations may
produce a noisy picture. To delete those stations, refer to
"Delete A Channel" (
Manual Channel Set
Store channels that were not stored during Auto Set Up or Auto
Channel Set.
A
Access Tuner Set screen
Perform step A of "Auto Channel Set".
B
Access channel list
rt
Press to place the pointer next to "CH EDIT", then press OK
e
or .
C
Select position
rt
Press to place the pointer next to an open channel position,
e
then press OK or .
D
Select band
Press rt to place the pointer next to the band of your choice,
then press OK to initiate Manual Channel Set.
BAND SELECT
VHF L
VHF H
UHF
[ / ]
[MENU] : EXIT
— 14 —
Dubbed tape
15).
15).
MANUAL CH SET
PLEASE WAIT
VHF L 300MHZ
[MENU] : EXIT