Cable Holder, Flat Cable And Printed Circuit; Mounting - Husqvarna 6690 Manual

Cable holder, flat cable and
printed circuit.

Mounting

Mount the cable holder (4/37) and allow the
outlet to go inside the holder (4/34) for the
fork spring. Fix the wiring from the step
motor of the needle bar at the uppermost
notch and from the feeding mechanism at
the lowest notch. Mount the flat cable from
the front panel and place the cable guard
(4/41) in such a way that the flat cable is
held against the printed circuit in the rear
cover. The flat cable from the fuse circuit is
44
run direct to the printed circuit. Stretch the
cables to the left. Mount the step motor drive
circuit in the rear cover. Put the spacing
sleeve (5/3) on the lower screw (5/4) in the
rear cover, place the plastic cone (11/46) at
the adjustment screw (11/31) and mount
the cover.
Mount the belt-guard and handwheel.