Table of Contents
Advertisement
Read and follow these safety precautions prior to operating
this appliance. Failure to follow these precautions may
result in death, injury, or property damage.
Sample Warnings and Definitions:
Indicates a hazardous situation which, if not avoided, will
result in death or serious injury.
Indicates a hazardous situation which, if not avoided, could
result in death or serious injury.
Indicates a hazardous situation which, if not avoided, could
result in minor or moderate injury.
NOTICE:
Addresses practices not related to personal injury.
Read all instructions before starting installation and follow them
carefully to insure safety. Failure to follow the instructions will
void the warranty and may cause a fire hazard.
NOTICE:
If the fireplace insert is installed into a modified wood-
burning, factory-built fireplace, the fireplace cannot be returned
to a wood-burning fireplace. See page 14 for additional details
regarding the allowed modifications to a factory-built fireplace.
The warranty will be voided by, and the warranter disclaims any
responsibility for the following actions:
•
Installation of any damaged fireplace insert or vent system
component.
•
Modification of the fireplace insert or direct vent system.
•
Installation other than as instructed by Empire Comfort
Systems Inc.
•
Improper positioning of logs, glass door, barrier screen, or
decorative accessories.
•
Installation and/or use of any component not manufactured
or approved by the manufacturer.
All correspondence should refer to complete Model Number,
Serial Number and type of gas. Fill out the Homeowner
Reference Section in Homeowner's manual on page 2.
Unpacking the fireplace insert
1.
Cut the binding straps.
2.
Remove the top carton.
3.
Carefully remove the carton contents.
4.
Use the Carton Contents and Hardware Pack lists on page 5
to verify all components are present.
5.
Verify that the fireplace insert and components have not
been damaged during shipping.
6.
Set the fireplace insert near installation location.
Page 4
BEFORE YOU START
WARNING
DANGER
WARNING
CAUTION
Preparation
This fireplace insert and its components are safe when installed
in accordance with this Installation Manual. Report any parts
damaged in shipment to your dealer. Do not install the fireplace
insert with damaged, incomplete or substitute parts.
Installation Considerations
•
The firebox must be in good working order and sized
according to pages 11 and 14.
•
Gas supply piping – right or left side entrance
•
Electrical supply and connections – for blower
•
120V, 60Hz, 1 Amp
•
Right side entrance
•
Surround Requirements - See Fireplace Insert Dimensions,
page 10 and Accessories, page 7.
•
Surround Bottom Cover - For elevated insert installations.
See dealer for custom surrounds.
•
Leveling the Insert - Four leveling bolts are included in the
Hardware Pack. See page 17 for installation and use.
Planning The Installation
1.
Read the safety information on pages 24 and 31.
2.
Place the sticker located in the instruction envelope onto
the "Homeowner Reference
manual on page 2.
3.
Show the homeowner where the rating plate and lighting
instruction plate are located.
4.
Install the venting. See pages 15 - 18.
5.
Install and connect the gas lines. See pages 12 and 13.
6.
Install the wiring. See page 22.
7.
Install the fireplace insert. See pages 17 - 21.
8.
Remove the barrier and door assemblies.
9.
Install the liners, log set, and rock wool. See their manuals.
10. Sync the remote. See page 19.
11. Install the surround. See page 20.
12. Reinstall the door assembly. See page 21.
13. Light the fireplace insert. See page 23.
14. Adjust the damper, air shutters, and rock wool for perfect burn.
15. Troubleshoot any issues. See pages 24 - 26.
16. Reinstall the barrier assembly.
17. Install the decorative front. See their manuals.
18. Show the homeowner how to operate the fireplace insert.
19. Show the homeowner how do the basic maintenance.
20. Instruct the homeowner to never attempt to adjust the air
shutters or damper.
TrueFlame Technology
This fireplace is equipped with TrueFlame Technology for
maximum flames and ember glow with minimum emissions. The
system includes independently controlled front and rear burners
set into a large ember bed plus a ceramic catalyst and externally
adjustable baffle mounted at the top. Once adjusted by the
dealer/technician at installation, the TrueFlame system requires
no further adjustment.
Information"
in Homeowner's
41921-0-0420
Advertisement
Table of Contents
