Advertisement
***Note: All features associated with the TraceTag can be activated by pressing the button
1. Exiting Standby Mode:
a. Press and hold the button on the bottom of the TraceTag for three seconds to take it
out of standby mode.
i. ***Note: The TraceTag will make a chirp and the LED light on the front will begin
to flash after this has been done successfully ***
2. Enter Standby Mode:
a. Press and hold the button on the bottom of the TraceTag for seven seconds to put it
back into standby mode.
i. ***Note: The TraceTag will make a chirp and the LED light on the front will stop
flashing after this has been done successfully.***
3. Silence for 3 minutes:
a. Press and hold the button on the bottom of the TraceTag for 3 seconds until you hear
the tag chirp.
4. Silence for 15 minutes:
a. After you have silenced the TraceTag for 3 minutes, you will need to repeat the same
action and hold the button on the bottom of the sensor for 3 seconds until you hear the
tag chirp again.
i. ***It is important to note that the two button presses must be done within 5
seconds of each other***
Triax Technologies Inc.
18 Marshall Street Suite 340
Norwalk, CT 06854
Proximity Trace - Button Features
on the bottom of the sensor***
(203) 803-9879
info@triaxtec.com
www.triaxtec.com
Advertisement
