Advertisement
Proximity Trace
Installation
1. Use the attached map to identify the specified hardware locations (noting the corresponding
numbers labeled on each pod) and plug the pod into the 110v power outlet once in the proper
location.
2. Install the included antenna on to the bottom of cloud pod (pictured below).
3. Switch the toggle button (picture below) into the "On" Position. Ensure the pod is getting power
based on the green light (fully charged and plugged in) or orange light (pod is connected to
power and the battery is charging) - see below.
4. After about two minutes the pod should connect. A blue light blinking every 10-30 seconds and
a green light blinking once every 10 seconds will be present.
After connection is confirmed reach out to your CES to make sure we have a good cell signal.
Inside Cloud Pod
On/Off Toggle Switch
Blue Light Blinking 10 -
30 seconds when
connected
18
Triax Technologies Inc.
18 Marshall Street Suite 340
Norwalk, CT 06854
Jake Holmon | (914) 299-8083 | jholmon@triaxtec.com
Green LED
Plugged-in Fully
Charged (Orange
indicates
Charging,
plugged in)
Green light
Blinking 10
seconds when
connected
(203) 803 - 9879
(203) 803-9879
For Support Please Contact:
Cloud Pod Mount
Zip - ties used for mounting
Antenna Facing Down
Power Plug
info@triaxtec.com
info@triaxtec.com
www.triaxtec.com
www.triaxtec.com
Advertisement
