Advertisement
Quick Links
STOP! DO NOT PROCEED UNTIL
CALIBRATION TESTING IS
Contact your Triax contact to complete calibration testing.
•
Take two tags out of standby mode by pressing and holding the button for three seconds. You
will hear it chirp on and see green flashing lights.
•
All tags are to be worn in the same general location by every worker with the QR code facing
out. We recommend the middle chest area.
•
All tags should be worn flat against the users body. No tag should be hung from a lanyard or put
into a pocket.
•
Plug in and turn on supplied gateway, keep within range of testing tags (line of site to tags)
•
Please note that the body can significantly affect the range of the tag. Workers behind or to
the sides of someone may not be picked up as easily as the face to face interaction.
With the QR code facing away from
the body, attach the TraceTag to the
workers shirt
Triax Technologies Inc.
18 Marshall Street Suite 340
Norwalk, CT 06854
COMPLETE.
Testing Requirements/Information
(203) 803-9879
Gateway to be turned on,
plugged in, and within range of
testing procedures
info@triaxtec.com
www.triaxtec.com
Advertisement
Summary of Contents for Triax TraceTag
- Page 1 STOP! DO NOT PROCEED UNTIL CALIBRATION TESTING IS COMPLETE. Contact your Triax contact to complete calibration testing. Testing Requirements/Information • Take two tags out of standby mode by pressing and holding the button for three seconds. You will hear it chirp on and see green flashing lights.
-
Page 2: Charging Procedure
Please note Triax does not recommend putting any users in danger of contracting Covid-19, and is simply providing test scenarios Correct Testing Procedure Charging Procedure • Battery life on the tags is 5-8 weeks depending on usage. • You can charge up to 5 tags in one charging dock. You do not need to fill the dock and can do as many as you have available to charge. - Page 3 Blinking 10 Antenna Facing Down seconds when connected Power Plug Blue Light Blinking 10 - 30 seconds when connected (203) 803 - 9879 info@triaxtec.com www.triaxtec.com Triax Technologies Inc. 18 Marshall Street Suite 340 Norwalk, CT 06854 (203) 803-9879 info@triaxtec.com www.triaxtec.com...
- Page 4 TraceTag Mounting Instructions: ***Note: Each TraceTag will need to be taken out of standby mode prior to being distributed to your workforce*** 1. Press and hold the button on the bottom of the TraceTag for three seconds to take it out of standby mode.
-
Page 5: Exiting Standby Mode
1. Exiting Standby Mode: a. Press and hold the button on the bottom of the TraceTag for three seconds to take it out of standby mode. i. ***Note: The TraceTag will make a chirp and the LED light on the front will begin to flash after this has been done successfully *** 2.