Position Menu; H-Position; V-Position; Dot Clock - Panasonic PT-AE300E Operating Instructions Manual

POSITION menu

Remote control
See "Navigating through the MENU" on page 29.
See "Main menu and sub-menu" on page 30.

H-POSITION

You can move the projected image horizontally for fine
adjustment.
Move left

V-POSITION

You can move the projected image vertically for fine
adjustment.
Move
down

DOT CLOCK

If you have interference patterns of the projected image,
which is sometimes referred to as moire or noise, you
can minimize it by pressing I H to adjust the clock
frequency. (Available with signals from COMPUTER IN
only)
NOTE:
• If the projecting signal's dot clock frequency is higher
than 150 MHz, the adjustment may not make a
difference.
• DOT CLOCK needs to be adjusted before adjusting the

CLOCK PHASE.

Control panel
Move
right
Move up
CLOCK PHASE
If you require further adjustment for the same reason as
the DOT CLOCK adjustment, you can fine adjust the
timing of the clock. Press I H to adjust. (Available with
signals from COMPUTER IN/COMPONENT IN only)
NOTE:
• If the projecting signal's dot clock frequency is higher
than 150 MHz, the adjustment may not make a
difference.
• Available signals from COMPONENT IN:
1 125 (1 080)/60i, 1 125 (1 080)/50i, 1 125 (1 080)/60p,
1 125 (1 080)/50p, 1 125 (1 080)/24p, 750 (720)/60p,
750 (720)/50p.

ASPECT

You can switch the aspect ratio manually when needed.
Aspect ratio depend on signals
Press I H to cycle through the aspect ratio
options. The cycle pattern depends on the
connected signals.
4:3 \ 16:9 \ s16:9 \ JUST \ ZOOM
\ AUTO
NTSC, NTSC 4.43, PAL-M, PAL60
VIDEO/
signals
S-VIDEO
4:3 \ 16:9 \ s16:9 \ 14:9 \ ZOOM1
\ ZOOM2 \ JUST
PAL, PAL-N, SECAM signals
4:3 \ 16:9
VGA, SVGA, XGA, SXGA, MXGA signals
COMPUTER
(RGB)
Not switchable with WIDE 720/768/768-2/
800/900 signals
4:3 \ 16:9 \ s16:9 \ H - FIT \ V - FIT
\ ZOOM
1 125 (1 080)/50i, 1 125 (1 080)/60i,
1 125 (1 080)/50p, 1 125 (1 080)/60p,
1 125 (1 080)/24p, 750 (720)/50p and
HDMI
750 (720)/60p signals
4:3 \ 16:9 \ s16:9 \ JUST \ ZOOM
525i (480i), 625i (576i), 525p (480p) and
625p (576p) signals
4:3 \ 16:9 \ s16:9 \ 14:9 \ ZOOM1
\ ZOOM2 \ JUST
625i (576i), 625p (576p) signals
AUTO \ 4:3 \ 16:9 \ s16:9 \ JUST
\ ZOOM
COMPONENT 525i (480i), 525p (480p) signals
(YP P )
B R
4:3 \ 16:9 \ s16:9 \ H - FIT \
V - FIT \ ZOOM
1 125 (1 080)/50i, 1 125 (1 080)/60i,
1 125 (1 080)/50p, 1 125 (1 080)/60p,
1 125 (1 080)/24p, 750 (720)/50p,
750 (720)/60p signals
E
NGLISH - 37