Table of Contents
Advertisement
TROUBLESHOOTING
50
EN
Warning Indications
Displays the battery remaining power.
Remaining power level
High
As the battery power comes close to nil, the battery
indicator blinks.
When the battery power is exhausted, power turns off
automatically.
Appears when no tape is loaded. (
CHECK TAPE'S ERASE PROTECTION TAB
Appears when the erase protection tab is set to "SAVE"
while the Power Switch is set to "A" or "M" and the
VIDEO/MEMORY Switch is set to "VIDEO". (
USE CLEANING CASSETTE
Appears if dirt is detected on the heads during recording.
Use an optional cleaning cassette. (
CONDENSATION, OPERATION PAUSED
PLEASE WAIT
Appears if condensation occurs. When this indication is
displayed, wait more than 1 hour until condensation
disappears.
TAPE!
Appears if a tape is not loaded when the Recording Start/
Stop Button or SNAPSHOT Button is pressed while the
Power Switch is set to "A" or "M" and the VIDEO/
MEMORY Switch is set to "VIDEO".
TAPE END
Appears when the tape ends during recording or
playback.
SET DATE/TIME!
● Appears when the date/time is not set. (
● Appears when the built-in clock (lithium) battery is
discharged and the previously set date/time is erased.
(
pg. 14)
LENS CAP
Appears for 5 seconds after power is turned on if the lens
cap is attached or when it is dark.
A. DUB ERROR!
Appears if Audio Dubbing is attempted on a blank portion
of a tape. (
pg. 43)
A. DUB ERROR!
<CANNOT DUB ON A LP RECORDED TAPE>
<CANNOT DUB ON A 16BIT RECORDING>
<CHECK TAPE'S ERASE PROTECTION TAB>
● Appears if Audio Dubbing is attempted on a tape
● Appears if Audio Dubbing is attempted on a tape
Exhausted
● Appears if A. DUB (D) on the remote control is pressed
INSERT ERROR!
Appears if Insert Editing is attempted on a blank portion
pg. 15)
of a tape. (
INSERT ERROR!
<CANNOT EDIT ON A BLANK PORTION>
<CANNOT EDIT ON A LP RECORDED TAPE>
pg. 13)
<CHECK TAPE'S ERASE PROTECTION TAB>
● Appears if Insert Editing is attempted on a blank portion
● Appears if Insert Editing is attempted on a tape
pg. 53)
● Appears if INSERT (I) on the remote control is
MEMORY IS FULL
Appears when the memory card's memory is full and
shooting is not possible.
COPYING FAILED
● Appears if dubbing of copyguarded signals is attempted
● Appears in the following cases when dubbing from a
pg. 14)
MEMORY CARD!
Appears if there is no memory card loaded when you
attempt to record on a memory card or access data on a
memory card.
PLEASE FORMAT
Appears when there is a problem with a memory card
and its memory is corrupt, or it has not been initialised.
Initialise the memory card. (
NO IMAGES STORED
Appears if there are no image files stored in the memory
card when you attempt memory card playback.
recorded in the LP mode. (
recorded in 16-BIT audio. (
when the erase protection tab is set to "SAVE".
(
pg. 43)
pg. 43)
of a tape.
recorded in the LP mode. (
pressed when the erase protection tab is set to "SAVE".
(
pg. 43)
while this camcorder is being used as a recorder.
tape to a memory card (as digital stills or video clips):
• when no memory card is loaded.
• when the memory card's memory is full.
• when the memory card is not formatted.
• when a write-protected SD Memory Card is loaded.
(
pg. 26)
pg. 43)
pg. 43)
pg. 43)
pg. 28)
Advertisement
Table of Contents
