Table of Contents
Advertisement
Digital Dubbing
It is also possible to copy recorded scenes from the camcorder onto other video unit equipped with a DV
connector. Since digital signal is sent, there is little if any image or sound deterioration.
1
CONFIRM POWER-OFF STATUS
Make sure the camcorder's power is off.
2
MAKE CONNECTIONS
Connect the camcorder to your video unit
equipped with a DV connector using the DV
cable (optional) as shown in the illustration.
3
START PLAYBACK
Press the Play button (4) to play back the
source tape.
4
START RECORDING
While watching the playback on the LCD
monitor, engage the DV connector-equipped
video unit's record mode from the spot on the
source tape you want to begin recording.
Downloaded from:
To DV OUT
connector
To AC outlet
To DC IN jack
Core filter
DC cord
https://www.usersmanualguide.com/
RM-V711U
(provided)
DV cable (optional)
To DC OUT jack
NOTES:
● You cannot use the battery pack installed in the
camcorder as the power supply since a digital
signal is output from the DV OUT connector only
when using the AC Power Adapter/Charger.
● When using the camcorder for dubbing, be sure
to use it as a player. The camcorder's DV
connector is only for output.
● If a blank portion is played back during dubbing,
an unusual image may be dubbed.
● Even though the DV cable is connected correctly,
sometimes the image may not appear in step 3. If
the above occurs, turn off power and make
connections again.
● The image with Fade/Wipe Effects and P.AE/
Effects is not output from the DV OUT connector.
Only the original playback image is output from
it.
T
W
PLAY
STOP
To DV
connector
Video unit equipped
with DV connector
AC Power
Adapter/Charger
1
61
EN
Advertisement
Table of Contents
