Advertisement
Replacing the Lamp unit
CAUTION:
When the projector is mounted on a ceiling, do not work with your face close to the
z
projector.
Attach the lamp unit and the lamp cover securely.
z
When you experience difficulty in installing the lamp, remove it and try again. If you
z
use force to install the lamp, the connector may be damaged.
z Do not use other than designated lamp units.
z Do not lossen other than designated screws.
Replacement procedure
J
1) Turn off the Power by following the
procedure in "Turning off the projector".
Unplug the AC power cord. Wait at least
1 hour and make sure the lamp unit and
surroundings are cool.
2) Use a Phillips screwdriver to loosen the
lamp cover fixing screw and open the
lamp cover.
Open the lamp cover, slide the lamp cover in
z
the direction of the arow shown in the right
picture and let the projector stand on the
side at the same time.
3) Use a Phillips screwdriver to loosen the
three lamp unit fixing screws until the
screws turn freely. Hold the used lamp
unit by its handles, and pull it gently
from the projector.
4) Insert the new lamp unit in correct
direction. Tighten the three lamp unit
fixing screws securely with a Phillips
screwdriver.
5) Close the lamp cover, and tighten the
lamp cover fixing screw securely with a
Phillips screwdriver.
Close the lamp cover by pushing it slowly
z
opposite to the direction of the arrow.
Note
z When you replace the new lamp unit (ET-
LAE200), the projector resets the total
usage time of the lamp unit automatically.
Lamp cover
Lamp cover
fixing screw
Lamp unit fixing screws
Handles
E-7
Advertisement
