Advertisement
Replacing the Lamp unit
CAUTION:
When the projector is mounted on a ceiling, do not work with your face close to the
z
projector.
Attach the lamp unit and the lamp cover securely.
z
When you experience difficulty in installing the lamp, remove it and try again. If you
z
use force to install the lamp, the connector may be damaged.
Do not use other than designated lamp units.
z
Do not loosen other than designated screws.
z
Replacement procedure
J
1) Turn off the Power and unplug the
AC power cord. Wait at least 1 hour
and make sure the lamp unit and
surroundings are cool.
2) Use a Phillips screwdriver to loosen the
lamp cover fixing screw and open the
lamp cover.
Remove the lamp cover by pulling it slowly
z
toward the direction of the arrow.
3) Use a Phillips screwdriver to loosen the
three lamp unit fixing screws until the
screws turn freely. Hold the used lamp
unit by its handles, and pull it gently
from the projector.
4) Insert the new lamp unit in correct
direction. Tighten the three lamp unit
fixing screws securely with a Phillips
screwdriver.
5) Attach the lamp cover, and tighten the
lamp cover fixing screw securely with a
Phillips screwdriver.
Attach the lamp cover by pushing it slowly
z
opposite the direction of the arrow.
Note
z When you replace the new lamp unit (ET-
LAV200), the projector resets the total
usage time of the lamp unit automatically.
Lamp cover
Lamp cover
fixing screw
Lamp unit fixing screws
Lamp unit
Lamp unit
E-7
Advertisement
