Table of Contents
Advertisement
FOR YOUR SAFETY READ BEFORE OPERATING
WARNING: If you do not follow these instructions exactly, a fire or explosion
may result causing property damage, personal injury or loss of life.
A This appliance is equipped with an
ignition device which automatically
ignites the pilot. Do not try to light the
pilot by hand
B. BEFORE OPERATING smell all around
the appliance area for gas. Be sure to
smell next to the floor because some
gas is heavier than air and will settle on
the floor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance
• Do not touch any electrical switch
• Do not use any phone in your building
• Immediately call your gas supplier from
STOP Read the safety information
above.
• To turn the unit on (refer diagram
below)
SETTING
BUTTONS
FAN
1. Pilot
Off/On
2. Low
Low/Off
3. High
High (Auto)
Do not attempt to light the pilot by hand.
Wait for five minutes to clear out any gas.
Then smell for gas, including near the floor.
If you smell gas, STOP! Follow "B" in the
safety information. If you don't smell gas,
go to the next step.
Press the first control button firmly. This
operates the built in safety device and
starts the electronic spark.
Place the gas control in the off position (all
buttons up / out) and turn off the power at
the switch.
OPERATING INSTRUCTIONS
BURNER PATTERN
TO TURN OFF GAS TO APPLIANCE
8
a neighbor's phone. Follow the gas
suppliers instructions.
• If you cannot reach your gas supplier call
the fire dept.
C. Use only your hand to push the gas
control buttons. Never use tools. If the
buttons will not activate by hand, don't
try and repair it, call a qualified service
technician. Force or attempted repair
may result in a fire or an explosion.
D. Do not use this appliance if any part has
been under water. Immediately call a
qualified service technician to inspect
the appliance and to replace any part
of the control system and any gas control
which has been under water.
Visually check the pilot has lit and continue
to hold the button for up to 15 seconds.
If the pilot does not remain alight, push the
button again and release it. This will return
it to the off position. Wait 30 seconds and
repeat the ignition procedure.
• To turn on the heat
Press the center button, this will ignite the
front burner, then press the remaining button
to ignite the main burner.
• To decrease the heat
Release the last two control buttons in the
reverse order.
• To turn the unit off
Release all three buttons to the off position.
Disconnect the electric plug. This will
prevent accidental ignition if the gas
control valve is operated.
Advertisement
Table of Contents
