www.seagate.com
2.6
Start/stop times
The start/stop times are listed below.
Power-on to ready
(in seconds)
Standby to ready
(in seconds)
Ready to spindle stop
(in seconds)
Time-to-ready may be longer than normal if the drive power is removed without going through normal OS powerdown
procedures.
2.7
Power specifications
The drive receives DC power (+5V or +12V) through a native SATA power connector. Refer to
2.7.1 Power consumption
Power requirements for the drives are listed in
tested, under nominal conditions, using 5.0V and 12.0V input voltage at 25°C ambient temperature. These power
measurements are done with DIPM enabled.
• Spinup current is measured from the time of power-on to the time that the drive spindle reaches operating
speed.
• Operating Power is measured following IDEMA 3 streams standard, assuming CE operating condition
• The drive supports three idle modes: Performance Idle mode, Active Idle mode and Low Power Idle mode.
Refer to
Section 2.7.4
for power-management mode.
Table 2
DC power requirements (2TB-1TB)
Power dissipation
Spinup
Idle, Low Power
Operating Power
Standby
Sleep
Seagate SkyHawk Lite Product Manual, Rev. E
1-Disk models
9 (typical)
9 (typical)
10 (typical)
Table 2
. Typical power measurements are based on an average of drives
Avg (watts 25° C)
Avg 5V typ amps
—
2.5
3.5
0.25
0.25
Avg 12V typ amps
—
1.1
0.12
0.15
0.24
0.191
0.04
0.004
0.04
0.004
Drive Specifications
.
Figure 2 on page 21
11