Pioneer DMH-T450EX Installation Manual page 8

Factory radio-mounting bracket
If the pawl interferes with
installation, you may bend it down
out of the way.
Dashboard or console
Truss head screw or flush surface
screw
Be sure to use the screws supplied
with this product.
Attaching the display
to this product
NOTE
Do not use this product with the display
removed.
1
Attach the display cable ( ) to the
display.
Insert the display cable connector ( )
in the direction of the arrow.
CAUTION
Insert the connector with the connector
projection ( ) side facing up. If you force
to insert the connector in upside down, it
may be broken.
8
En
NOTE
Push the display cable as far as possible in
this product before attaching the display.
2
Attach the display to the mounting
bracket.
Slide the display downward slowly until
it stops at the bottom while sliding the
lever ( ) on both sides in the direction
of the arrow.
NOTE
If you cannot slide the display to the
bottom, install the display by sliding it to
the position indicated by the dashed line in
the figure below.
3
Attach the cable cover ( ) to the
display.
Pinch the lever ( ), and then insert the
cable cover ( ) to the bottom of back of
the display in the direction of the arrow.
NOTE
If the cover does not fit properly, make sure
that the display is slid to the position
indicated by the dashed line in the figure
below.