Pioneer DMH-WT3800NEX Operation Manual page 107

Rds av receiver
Hide thumbs Also See for DMH-WT3800NEX:
Table of Contents

Advertisement

– Touch
to display the home menu
screen.
 The smartphone OS may be awaiting
screen operation.
– Stop the vehicle in a safe place and
check the screen on the smartphone.
The screen is displayed, but operation
does not work at all.
 An error has occurred.
– Park your vehicle in a safe place, and
then turn off the ignition switch (ACC
OFF). Subsequently, turn the ignition
switch to on (ACC ON) again.
– When an Android device is connected,
disconnect the Bluetooth connection
from this product and then reconnect
it.
The smartphone was not charged.
 Charging stopped because the
temperature of the smartphone rose
due to prolonged use of the
smartphone during charging.
– Disconnect the smartphone from the
cable, and wait until the smartphone
cools down.
 More battery power was consumed
than was gained from charging.
– This problem may be resolved by
stopping any unnecessary services on
the smartphone.
Error messages
When problems occur with this product, an
error message appears on the display.
Refer to the table below to identify the
problem, then take the suggested
corrective action. If the error persists,
record the error message and contact your
dealer or your nearest Pioneer service
center.
Common
AMP Error
 This product fails to operate or the
speaker connection is incorrect; the
protective circuit is activated.
– Check the speaker connection. If the
message fails to disappear even after
the engine is switched off/on, contact
your dealer or an authorized Pioneer
Service Station for assistance.
Product overheat. System will be shut
down automatically in 15 seconds.
Restart the product by ACC-Off/On may
fix this problem. If this message keeps
showing up, it is possible that some
problem occurred in the product.
 The temperature of the main unit is too
high.
– Turn off the ignition switch (ACC OFF)
then wait until the main unit
temperature reaches low.
SiriusXM® Satellite Radio
Check Antenna
 The antenna connection is incorrect.
– Check the antenna connection. If the
message fails to disappear even after
the engine is switched off/on, contact
your dealer or the nearest authorized
Pioneer service center for assistance.
Check Tuner
 The SiriusXM Connect Vehicle Tuner
connection is incorrect.
– Check the tuner connection and
battery voltage. If the message fails to
disappear even after the engine is
switched off/on, contact your dealer
or the nearest authorized Pioneer
service center for assistance.
- 107 -

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dmh-wt38nex

Table of Contents