Table of Contents
Advertisement
52
www.aeg.com
Problem
The washing results
are not satisfactory.
Too much foam in the
drum during the wash‐
ing cycle.
The detergent/fabric
softener level does not
decrease in the Auto‐
Dose tanks after wash‐
ing.
After the check, activate the appliance. The programme continues
from the point of interruption.
If the problem occurs again, contact the Authorised Service Centre.
The necessary data for the service centre are on the rating plate.
16. CONSUMPTION VALUES
16.1 Introduction
See the web link www.theenergylabel.eu for
detailed information about Energy Label.
For Non EU
The QR code on the energy label supplied with the
appliance provides a web link to the product
information sheet. Keep the energy label for
reference together with the user manual and all
other documents provided with this appliance.
Possible solution
•
Increase the detergent quantity or use a different detergent.
•
Use special products to remove the stubborn stains before
you wash the laundry.
•
Make sure that you set the correct temperature.
•
Decrease the laundry load.
•
When using AutoDose tanks, make sure that they are not
empty.
•
When using AutoDose tanks, verify the pre-set detergent/
fabric softener dosage. Refer to "Basic setting" paragraph in
"The AutoDose Technology" chapter.
•
Make sure that you have cleaned the AutoDose tanks before
using different brand and type of detergent, fabric softener or
other additives.
•
Reduce the quantity of detergent.
•
When using AutoDose tanks, verify the pre-set detergent/
fabric softener dosage. Refer to "Basic setting" paragraph in
"The AutoDose Technology" chapter.
•
This is normal: tanks are quite large and detergent consump‐
tion may be not so evident.
Advertisement
Table of Contents
