Table of Contents
Advertisement
• You make an invalid selection (3 short
sounds).
• The programme is completed
(sequence of sounds for about 2
minutes).
• The appliance has a malfunction
(sequence of short sounds for about 5
minutes).
To activate/deactivate the acoustic
signals when the programme is
completed, touch the Prewash and the
Stains buttons simultaneously for about 2
seconds. The display shows On or Off.
If you deactivate the
acoustic signals, they
continue to operate when
the appliance has a
malfunction.
9.2 Operating Hours Counter
It is possible to visualise the total
operating time of the appliance in hours,
starting from the first switching on. This
value will count operating time of the
cycles (does not include pauses, delayed
start time). To visualise this value,
proceed as follows:
1. Switch the appliance on by pressing
On/Off button.
2. Turn the programme knob to the Eco
40-60 programme (1st position
clockwise).
3. Press and hold the Prewash and
Stains buttons for some seconds
(within 10 seconds after the switching
on. After these 10 seconds, the key
combination activates and
deactivates the acoustic signals).
4. After 3 seconds the total hours
operated by the appliance are shown
10. BEFORE FIRST USE
1. Make sure that the electrical power is
available and the water tap is open.
2. Pour 2 litres of water into the
detergent compartment marked by
.
This action activates the drain system.
3. Pour a small quantity of detergent
into the compartment marked by
in the display: e.g. 1276 hours, the
display shows the text Hr for 2
seconds, 12 (thousands and
hundreds) for 2 seconds and 76 (tens
and units).
If the procedure does not
work (due to timeout, wrong
programme dial position or
wrong keys combination),
switch the appliance off and
repeat sequence from the
beginning.
9.3 Factory Reset
This function allows to restore the factory
default options. To activate this option
follow steps below:
1. Switch the appliance on by pressing
On/Off button.
2. Turn the programme knob to the
Synthetics programme (3rd position
clockwise).
3. Press and hold the Prewash and
Stains buttons for some seconds
(within 10 seconds after the switching
on. After these 10 seconds, the key
combination activates and
deactivates the acoustic signals).
4. The display will show
about 5 seconds.
If the procedure does not
work (due to timeout, wrong
programme dial position or
wrong keys combination),
switch the appliance off and
repeat sequence from the
beginning.
4. Set and start a programme for cotton
at the highest temperature without
any laundry in the drum.
This removes all possible dirt from the
drum and the tub.
.
ENGLISH
29
for
Advertisement
Table of Contents
