ZyXEL Communications NAS320 User Manual page 184

Chapter 9 Network
Telnet access lets you use line commands to configure the NSA. Use these
commands at your own risk. The vendor takes no responsibility for any
changes you make using the commands.
Click Network > Telnet in the navigation panel to open the following screen.
Figure 70 Network > Telnet
The following table describes the labels in this screen.
Table 34 Network > Telnet
LABEL
Enable Telnet
Service
Apply
Reset
184
DESCRIPTION
Select this to enable Telnet access to the NSA. Clear it to not allow Telnet access to the
NSA.
To use Telnet, log in as "admin" or "root" and use the admin password.
Click this to save your changes.
Click this to restore previously saved settings.
Media Server User's Guide