Advertisement
Battery Installation
1,5V x 3
"AAA" (LR03)
1,5V
"AA" (LR6)
We recommend the use of alkaline
batteries for longer battery life.
Vehicle
• Loosen the screws in the bottom of
the vehicle with a Phillips screwdriver.
Lift the top of the vehicle off of
the chassis to access the battery
compartment. Insert one "AA" (LR6)
alkaline battery.
• Replace the top of the vehicle and
tighten the screw with a Phillips
screwdriver. Do not over-tighten.
• If the vehicle begins to operate erratically,
you may need to reset the electronics.
Remove the battery and replace it in
the vehicle.
IMPORTANT! Under normal use conditions, the battery in the vehicle will require
replacement more often than the batteries in the remote controller. For additional
information, refer to the troubleshooting section on the last page of this sheet.
Remote Controller
• Locate the battery compartment on the bottom
of the remote controller.
• Loosen the screw in the battery compartment
door with a Phillips screwdriver. Remove the
battery compartment door and insert three
"AAA" (LR03) alkaline batteries.
• Replace the battery compartment door and
tighten the screw with a Phillips screwdriver.
Do not over-tighten.
• If the remote controller begins to operate erratically,
you may need to reset the electronics. Remove the
batteries and replace them in the remote controller.
• Protect the environment by not
disposing of this product with
household waste (2002/96/EC).
Check your local authority for
recycling advice and facilities
(Europe only).
y,
r.
2
Advertisement
