Consumer Information IMPORTANT! For stage 2 use, please take a few moments to WARNING review the following safety tips: • Please use with caution as this product requires skill to operate To avoid serious injury: safely to avoid falls, collisions, and injuries to yourself (the rider) and others.
Page 3
Parts Decoration CAUTION This product contains small parts in its unassembled state. For adult assembly only. Collar Collar • Wipe the areas where the labels will be applied with a clean, dry Handlebar Handlebar cloth to remove any oils before applying labels. Extension Tube Extension Tube •...
Page 4
Stage 1 Assembly Sit & Scoot Mode Sit & Scoot Mode Board Board Wheel Assembly Wheel Assembly • • With the seating area upright With the seating , slide the board onto the front wheel assembly. wheel assembly. Hint: The board and front wheel assembly are designed to fit one Hint: The board an way for stage 1 use.
Page 5
Stage 1 Assembly Sit & Scoot Mode #10 x ¾˝ (1,9 cm) Screw Holes Holes • Insert a #10 x ¾˝ (1,9 cm) screw into the opposite side hole in • Align all four holes in the lower end of the extension tube with the the post and into the barrel nut.
Page 6
Stage 1 Assembly Sit & Scoot Mode • Insert two #8 x 1˝ (2,5 cm) screws into the holes in the collar and tighten. • Insert a #10 x ¾˝ (1,9 cm) barrel nut into the front hole in the post A.
Page 7
Stage 2 Assembly Stand & Scooter Mode Rear Wheel Rear Wheel Assembly Assembly • • Remove the rear wheel assembly from the board. Set the rear Remove the rear wheel a wheel assembly aside. It will be re-assembled in step 9. wheel assembly aside.
Page 8
Stage 2 Assembly Stand & Scooter Mode #8 x 1˝ (2,5 cm) Screws Collar Collar • Align the holes on the extension tube with the holes in handlebar. • First, insert a #10 x ¾˝ (1,9 cm) barrel nut into a hole in the extension tube A.
Page 9
Stage 2 Assembly Stand & Scooter Mode ˝ #8 x 1 (3,5 cm) Screws • Replace the four #8 x 1 ˝ (3,5 cm) screws into the board near the rear wheel assembly and tighten. • Align the holes in the handlebar assembly with the holes in the post.
1300 135 312 (Australia) To avoid serious injury: For stage 2 use, protective equipment should be worn. Use helmet, wrist guards, Fisher-Price, Inc., 636 Girard Avenue, East Aurora, NY 14052. kneepads and elbow pads. Hearing-impaired consumers: 1-800-382-7470. Outside the United States: Canada: Mattel Canada Inc., 6155 Freemont Blvd.,...