Panasonic Lumix DMC-LX1 Operating Instructions Manual page 107

n Folder Composition
Folders appear as follows.
SD Memory
D C I M
Card
MultiMedia
Card
M I S C
PRIVATE1
Folder number
1
File number
2
JPG : Pictures
3
MOV : Motion pictures
The contents of each folder are:
DCIM 100_PANA to 999_PANA
100_PANA Pictures/Motion pictures
MISC File with DPOF or favorite
setting
PRIVATE1 Flip animation files
• This unit stores up to 999 picture files in
each folder. A new folder is created after
this maximum is reached.
• To reset file and folder numbers, use
[NO.RESET] in the setup menu. (P25)
n Folder numbers are updated when:
• The folder containing the picture you just
shot had a file numbered 999 in it.
• You insert a card you had been using on
another manufacturer's camera that has a
file number 100 (e.g. 100_XXXXX,
XXXXX is the manufacturer's name, etc.)
immediately after using a card that had a
folder numbered 100. (That is, you insert
a card with the same number, irrespective
of the manufacturer.)
Connecting to a PC or Printer
100_PANA
1
100_PANA
P1000001.JPG
2 3
P1000002.JPG
P1000999.JPG
101_PANA
999_PANA
• You start shooting again after using
[NO.RESET] in the setup menus (P25). (It
is recorded to a new folder that has a
number following on from the one
previous. You can also reset the folder
number to 100 by using [NO.RESET]
immediately after formatting the card
when there are no folders or pictures on
the card.)
• If the remaining battery power is
exhausted during communication, the
recorded data may be damaged. When
you connect the camera to the PC, use a
battery with sufficient battery power (P14)
or the AC adaptor (DMW-AC5; optional).
• If the remaining battery power becomes
low during communication, the alarm
beeps. In this case, stop the
communication immediately.
• While [ACCESS] is being displayed, do
not disconnect the USB connection cable.
• For Windows 2000 users: Disconnect
the USB cable before changing the
card. Changing the card while the
cable is still connected can damage
the data on the card. (For details, refer
to the separate operating instructions
for PC connection.)
• Do not use any other USB connection
cables except the supplied one.
• Refer to the operating instructions of the
PC, too.
n About PictBridge (PTP) setting
• With Windows XP Home Edition/
Professional and Mac OS X, you can
leave the USB mode setting as
[PictBridge (PTP)].
• You can only load pictures from the
camera and cannot write them on the
card or delete them.
• When there are 1000 or more pictures on
a card, the pictures may not be imported.
107
VQT0S19